To configure the stove via the external WiFi module 4HEAT, you must first download the 4HEAT application on your device, register your credentials, and wait for the confirmation email.
Then launch the application and follow the step-by-step configuration procedure through the 4HEAT application.
Once registered, select "ADD 4HEAT" and follow the steps for configuration within the APP.
⚠️ WARNING:
- The home WiFi network must be set to 2.4 GHz.
- If the network operates only at 5 GHz, the 4HEAT will not be able to connect.
- The home WiFi password must not exceed 16 characters.
- Disable the phone’s data connection.
- Disable automatic reconnection to the home WiFi network.
- Enable all permissions requested by the app in the phone settings.
- The module must be connected only with the RS232 cable (it must not be connected to the power supply)
- WARNING: It is recommended not to use the “Reset” button hole located at the top right, as this operation could perform a hard reset of the hardware settings, with the consequent risk of damaging the system configuration, requiring component replacement, and compromising the proper functioning of the device.
Procedure in case of WiFi configuration failure
If the WiFi connection does not configure correctly, proceed with the reset of the external 4HEAT module by following the steps below:
- Press and hold the orange button marked with the 4HEAT symbol for about 30 seconds.
- After the reset is complete, restart the configuration procedure.
Comments
0 comments
Please sign in to leave a comment.