Changing the Code on the Remote Control

Air Stove

The procedure to change the remote control code is as follows:

1 - Disconnect the power supply.

2 - On the remote control, simultaneously press and hold the "OK" button and the power button.

3 - Press the "down arrow" button, select "New" and confirm with "OK".

4 - Choose a new code.

5 - Press "OK" and reconnect the power supply to the stove.

 

Note in case of failure to connect between remote control and control unit

If the remote control does not connect to the control unit, first check that the emergency display is working correctly and that not all LEDs are lit solid. If all the LED lights are on and steady, it is possible that one or more stove components are shorted and prevent the correct functioning of the display.

To perform a check:

• disconnect all components connected to the control unit,

• leave only the power supply and the flat cable of the emergency display connected,

• check if the emergency display resumes functioning correctly.

This procedure allows you to identify any components causing a short circuit.